Skin Application Instructions
iPhone 6 and iPhone 7 Glow Gel™ skin covers

STEP 1: Preparation

Find a clean, dust-free table or desk with good lighting and plenty of space to work. Wash your hands to remove any grease or natural oils and dry them thoroughly before application process.		  

STEP 2: Clean Your iPhone

With a soft cotton or microfiber cloth, gently clean your iPhone making sure to wipe away any dust or debris.

STEP 3: Peel

Peel your Glow Gel cover from its liner sheet backing. It should easily part from the smooth sheet liner and requires little pressure to pull off.  If for some reason the liner paper does stick to the base of the glow gel, gentle ease it off, so that sticky surface is exposed.		  

STEP 4: Position and Place

Holding the Glow Gel skin at its edges, guide it into place, using the camera cutout and edges to inform placement. Lay the skin as gently as you can onto your iPhone so you can check placement.

STEP 5: Apply Pressure

Once in place on your iPhone 6 or 7, firmly apply pressure to the Glow Gel cover to make sure it’s attached to your iPhone. Take a moment to admire it's beauty on your iPhone. Isn't is gorgeous! Ok, next step:		  

STEP 6: Front Skins

Holding gel at edges, slowly guide into position using fingers against iPhone to steady descent. Focus on aligning cutouts with camera, speaker & sensor while keeping skin within outer edges of iPhone face. Allow middle of gel skin to bow closer to iPhone to help you in the allignment process with cutouts.

STEP 7: Pressure & Placement

When skin cutouts are in the correct position as shown above, gently lay skin onto iPhone, apply pressure, and enjoy!		  


*A Note About Repositioning

It is recommended that Glow Gel skins be applied to your iPhone once to avoid potentially damaging skin. But if you need to reposition due to a mistake during the application process, you may use the following technique:

Using your finger nail or something pointy, slide toward corner of skin while lightly pressing downward to screen. As you make contact with glow gel, slide under the skin causing it to lift off of iPhone. Then gently peel remaining skin piece off surface with your fingers. **Make sure to peel up from under the base adhesive layer to avoid seperating the gel composite from bottom adhesive.